Hi i could be interested, what size is it, and the condition of it? and of course how much are you selling it for? Where are you as distance is important.
Regards
Mike in sunny norfolk
Search found 95 matches
- Fri Jan 09, 2009 11:58 pm
- Forum: General Discussion
- Topic: Spinnaker and Pole
- Replies: 8
- Views: 11434
- Thu Nov 27, 2008 6:04 pm
- Forum: General Discussion
- Topic: keel sticking in the mud!!!!!!
- Replies: 6
- Views: 7589
boat update
Have just viewed the emails, boat 99.999% Finished. have just to cover the foam cushions,and launch.!!!!! Have more photo`s to put on the site, including some of the keel being cast at the foundry,!! Thought it would be in the water by now,but had a few issues with my daughters health,and renovating...
- Thu Oct 09, 2008 9:07 pm
- Forum: General Discussion
- Topic: keel sticking in the mud!!!!!!
- Replies: 6
- Views: 7589
keel sticking in the mud!!!!!!
Went sailing the other day, nice and windy,in a cornish shrimper. had it heeling over a good bit, rubbing strake kissing the water.!!! (had full sails up with no reefs!) had a good time, but I had to keep raising and lowering the centre plate as it was fouling the bottom.This was at hickling broads,...
- Fri Sep 26, 2008 8:46 pm
- Forum: Rigging
- Topic: jib unfurling difficulty
- Replies: 6
- Views: 12822
rigging/forestay/roller reefing
Saw the comments, you might want to check the clearance INSIDE the rotor stay,and INSIDE the foil unit(ALLOY TUBE) when I made my roller unit I noticed that the bottle screw fixing unit runs very close to the alloy inside case ,!! could this be binding.? also check out the foil insides.The forestay ...
- Thu Sep 18, 2008 7:47 pm
- Forum: For Sale
- Topic: Out of date adds
- Replies: 7
- Views: 12002
old adds
boat moulds still for sale, covered with a tarp, and lots of leaves. if I am unable to sell soon, they might end up on the bonfire,or in landfill.!!! REGARDS MIKE IN SUNNY NORFOLK(today)
- Fri Jun 06, 2008 4:08 pm
- Forum: The Lounge
- Topic: SPINFLO COOKER/TRAILER
- Replies: 1
- Views: 6182
COOKER/GRILL
Have just seen pics of your new cooker/grill, from a health and safety viewpoint, I feel that you need to give it to me, to fully test it. !! Say for about 3years. then you can be sure that it is ok.!!! REGARDS MIKE IN WET AND DAMP NORFOLK
- Wed May 14, 2008 9:16 pm
- Forum: Maintenance
- Topic: "whacker" still leaking!
- Replies: 5
- Views: 10282
WATER LEAK
Have you any through hull fittings,?Tranducer,etc and is it possible to check around the keel pivot bolt for delamination of the grp from the inner lay-up(keel side) To the outer lay-up(final layers) inside the cabin. If the keel bolt pivots with the keel in the grp keel box,you WILL have water ingr...
- Thu Apr 24, 2008 9:17 pm
- Forum: General Discussion
- Topic: sails and headlinning/interior trim
- Replies: 0
- Views: 3010
sails and headlinning/interior trim
Having trouble contacting anybody,by e mail via the swift site,? PEOPLE CAN PHONE ME ON...01953681578 regarding sails rudder blades etc.. Have been reading the remarks about headlining ect with interest,as I AM NOW DOING MINE.! Pictures to follow.! I have used a thin foam sheet, 3mm thick(GREEN)like...
- Fri Apr 11, 2008 8:02 pm
- Forum: General Discussion
- Topic: strike a light!!!!!!r
- Replies: 2
- Views: 4575
strike a light!!!!!!r
Looking through this months isssue of P.B.O.(may) ,saw on page 99 (NEW GEAR) a spot light add .... set of 3 led battery powered spotlights .!!!!! ONLY 7.99......say marine and double the price!!! You can go to any BP garage and buy the same item at 2.99 ? without buying petrol.!!! WHAT A RIP OFF, th...
- Thu Feb 14, 2008 8:30 pm
- Forum: General Discussion
- Topic: MAST RAKE/KEEL ANGLE ETC..
- Replies: 7
- Views: 9626
MAST RAKE/KEEL ANGLE ETC.. boat build standard
NOPE, best bet is to check out your boat,and if in doubt ask.!! Washed the cockpit out today (UNCOVERED)removed 1/2 bucket of leaves and used two buckets hot water to remove the green slime, wished I had covered it up.!! REGARDS MIKE
- Wed Feb 13, 2008 10:43 pm
- Forum: General Discussion
- Topic: MAST RAKE/KEEL ANGLE ETC..
- Replies: 7
- Views: 9626
MAST RAKE/KEEL ANGLE ETC..
Having looked at about four swifts prior to my boat build,and another three since I started, I have yet to see any two the same,!!!!! each one is slightly different.!! When I veiwed one to measure and photograph the mast mount(tabernacle?) it had been fixed as far back as possible,close to the hatch...
- Wed Feb 13, 2008 10:28 am
- Forum: Tiller / Keel
- Topic: rudder stock /rudder blade
- Replies: 25
- Views: 31750
rudder stock /rudder blade
Read the remarks about rudder probs, you guys do know that I have the patterns and moulds for new rudders and stocks.???? The new alloy rudder stock that I make,is stronger than the old(SAME SHAPE BUT A BIT THICKER,AND 1/4 HARD) and the blade has a 1/4 thick alloyplate running the lenth of the blade...
- Sat Feb 09, 2008 1:45 pm
- Forum: General Discussion
- Topic: no chitchatI
- Replies: 1
- Views: 3743
SWIFT TRAILER
YOO,!!! Trailer work -repairs came to a stop about a month ago due to bad weather, but if this sunny HOT spell keeps up, will be able to finish it.!! Work to date...... both wheel bearings/hubs removed, and brake units serviced,hubs cleaned up on lathe and re-painted. New bearings bought from local ...
- Sat Feb 09, 2008 1:20 pm
- Forum: General Discussion
- Topic: no chitchatI
- Replies: 6
- Views: 8121
led lights
Terry,read your reply,will be using some interior light units ex car breakers for the inside but normal nav -lights for outside,keep seing them for sale ,be interested to see how they work out,as they are not that cheap,but should last longer.! REGARDS,..MIKE IN BLAZING SUNNY NORFOLK
- Fri Feb 08, 2008 9:53 pm
- Forum: General Discussion
- Topic: no chitchatI
- Replies: 6
- Views: 8121
no chitchatI
I suppose everybody is hibernating,? no chit chat anymore.!! regards to all MIKE in sunny and steamyHOT, HOT HOT norfolk