clipper wind

Discussions related to onboard electronic toys
Post Reply
David mclardie
Under way
Posts: 17
Joined: Thu May 28, 2009 9:19 pm

clipper wind

Post by David mclardie » Sun May 31, 2009 5:37 pm

Hi all i am looking to fit a clipper wind 2 to my swift just thought i would ask is ther any problems with fitting one to a swift mast is ther any extra brackets i will need to get the head unit to fit properly..
cheers David

helenandpete
Under way
Posts: 23
Joined: Sun Oct 12, 2008 9:02 pm
Location: Warwickshire

clipper wind

Post by helenandpete » Sun May 31, 2009 7:12 pm

Hi David
<![if !supportEmptyParas]> <![endif]>
I have a Clipper Wind on Tadpole and although it was fitted when I got her the standard masthead kit seems to do just fine. The only problem I have had is with the through deck plug and socket. The last owner fitted the unit and used Bulgin Buccaneer 6 pin plug and socket (Very good waterproof fittings) but did not connect the cable screen. Nasa sent me a copy of their 5 pin connection diagram which showed the screen needs to be connected.
<![if !supportEmptyParas]> <![endif]>
Pete
<![if !supportEmptyParas]> <![endif]>
-----Original Message-----
From: David mclardie [mailto:forum-electronics@swift18.org]
Sent: 31 May 2009 18:37
To: forum-electronics@swift18.org
Subject: [Swift 18] clipper wind
<![if !supportEmptyParas]> <![endif]>
Hi all i am looking to fit a clipper wind 2 to my swift just thought i would ask is ther any problems with fitting one to a swift mast is ther any extra brackets i will need to get the head unit to fit properly..
cheers David
<![if !supportEmptyParas]> <![endif]>

Post generated using Mail2Forum (http://www.mail2forum.com)
Best Regards

Peter

David mclardie
Under way
Posts: 17
Joined: Thu May 28, 2009 9:19 pm

Post by David mclardie » Wed Jun 03, 2009 1:57 pm

ok thanks for that ..David

Post Reply