Hi Rob, sorry for not getting back to you sooner. I don't have the end fitting that you have. I rang Holts and they told me that it's normal to use Monel Seizing wire. It's then covered with some tape and a spreader boot.
Thanks for the advice.
Andy
Search found 6 matches
- Tue May 05, 2015 8:07 pm
- Forum: Rigging
- Topic: Spreader/shroud attachmentt
- Replies: 3
- Views: 6679
- Tue May 05, 2015 7:55 pm
- Forum: Tiller / Keel
- Topic: Raymarine ST2000 fitting problems
- Replies: 0
- Views: 6187
Raymarine ST2000 fitting problems
Hi, I have recently bought an ST2000 thinking it would be easy to fit to my Swift 18. The supplied pin that is fitted on the tiller is vertical when the tiller is in the centre position. However, when you push the tiller over to port or starboard the pin tilts to an angle restricting the travel of t...
- Sun Mar 29, 2015 11:32 am
- Forum: Rigging
- Topic: Spreader/shroud attachmentt
- Replies: 3
- Views: 6679
Spreader/shroud attachmentt
Does anyone have any pictures of the fitting that is used to secure the shroud to the end of the spreader. My spreaders have a small slot for the wire to fit into and then a small hole directly behind. I discovered that the previous owner had used some very narrow gauge wire using the little hole to...
- Fri Jun 27, 2014 6:15 pm
- Forum: Tiller / Keel
- Topic: Rudder and Stock
- Replies: 4
- Views: 7589
Hi John, I live near to Townley Park - Woodgrove Road over from Big Billy. Does it bring back memories.
My e-mail address is hibbsy1961@virginmedia.com
Really kind of you mate.
Andy
My e-mail address is hibbsy1961@virginmedia.com
Really kind of you mate.
Andy
- Fri Jun 27, 2014 2:40 pm
- Forum: Tiller / Keel
- Topic: Rudder and Stock
- Replies: 4
- Views: 7589
- Mon Jun 23, 2014 9:14 pm
- Forum: Tiller / Keel
- Topic: Rudder and Stock
- Replies: 4
- Views: 7589
Rudder and Stock
Hi everyone, just joined so not found my way round yet. Hopefully posted this in the right place. The original rudder stock on my Swift 18 (Southern Mist) was split at the bottom both sides so I had it welded which seems to be holding at least for the time being. The rudder itself was in a poor stat...